BA 5
Single direction thrust ball bearingSingle direction thrust ball bearings can accommodate axial loads in one direction. They must not be subjected to any radial load. Their separable components facilitate mounting/dismounting and maintenance inspections. Many of the components are interchangeable. The shaft washers have a ground bore that enables an interference fit.
- Separable design facilitates mounting/dismounting and maintenance inspections
- Interchangeable components
- Ground bore of shaft washers enable interference fit
Description
Dimensions
| d | 5 mm | Bore diameter |
|---|---|---|
| D | 12 mm | Outside diameter |
| H | 4 mm | Height |
| d1 | ≈ 11.8 mm | Outside diameter shaft washer |
| D1 | ≈ 5.2 mm | Inner diameter housing washer |
| r1,2 | min. 0.15 mm | Chamfer dimension washer |
Abutment dimensions
| da | min. 8 mm | Abutment diameter shaft |
|---|---|---|
| Da | max. 9 mm | Abutment diameter housing |
| ra | max. 0.15 mm | Fillet radius |
Calculation data
| Basic dynamic load rating | C | 0.852 kN |
|---|---|---|
| Basic static load rating | C0 | 0.965 kN |
| Fatigue load limit | Pu | 0.036 kN |
| Reference speed | 20 000 r/min | |
| Limiting speed | 28 000 r/min | |
| Minimum load factor | A | 0.000005 |
Mass
| Mass bearing (including seat washer where applicable) | 0.0021 kg |
Tolerances and clearances
Bearing data
Bearing interfaces
