GX 30 F
Thrust spherical plain bearing, maintenance-free, metric sizesThrust spherical plain bearings are designed to accommodate axial and combined radial and axial loads. This specific design includes a steel/PTFE FRP sliding contact surface combination that is maintenance-free. However, relubrication, which can be applied from both sides, can extend bearing service life.
- Designed for axial and combined radial and axial loads
- Separable shaft and housing washers enable easier mounting
- Long service life and maintenance-free
- Relatively insensitive to contaminants
- Low coefficient of friction
Description
| Sliding contact surface combination | Steel/PTFE FRP |
| Material, shaft washer | Bearing steel |
| Material, housing washer | Bearing steel |
| Relubrication feature | Without |
| Sealing | Without |
Dimensions
| d | 30 mm | Bore diameter |
|---|---|---|
| D | 75 mm | Outside diameter |
| T | 26 mm | Height |
| α | 3.7 ° | Angle of tilt |
| dk | 82 mm | Raceway diameter inner ring (sphere diameter shaft washer) |
| d1 | 70 mm | Outside diameter inner ring (shaft washer) |
| D1 | 42 mm | Bore diameter outer ring (housing washer) |
| B | 19 mm | Height inner ring (shaft washer) |
| C | 19 mm | Height outer ring (housing washer) |
| r1 | min. 1 mm | Chamfer dimension |
| s | 17.5 mm | Distance sphere diameter centre – shaft washer back face (large inner ring side face) |
Abutment dimensions
| da | min. 56 mm | Abutment diameter shaft |
|---|---|---|
| Da | max. 59 mm | Abutment diameter housing |
| ra | max. 1 mm | Fillet radius |
Calculation data
| Basic dynamic load rating – axial direction | C | 95 kN |
|---|---|---|
| Basic static load rating – axial direction | C0 | 153 kN |
| Specific dynamic load factor | K | 50 N/mm² |
| Specific static load factor | K0 | 80 N/mm² |
| Material constant | KM | 670 |
Mass
| Mass plain bearing | 0.61 kg |
