SNLN 3026 + 23026-2CS5K/VT143 + H 3026 E
The combination of housings, bearings and accessories is an excellent choice for a customized, reliable and sustainable solution for your shaft arrangement. Has a wide range of high-quality housing designs and sizes to meet your specific challenge – including specially designed housings for special applications.
- Many variants
- Customized combinations
- Cost-efficient
- Reliable
- Sustainable
Description
Associated products
| Housing | SNLN 3026 |
| Bearing | 23026-2CS5K/VT143 |
| Adapter sleeve | H 3026 E |
| Locating ring | 2 x FRB 13.5/200 |
Dimensions
| da | 115 mm | Shaft diameter |
|---|---|---|
| Ca | 79 mm | Width of bearing seat |
| Da | 200 mm | Diameter of bearing seat |
| A | 175 mm | Width |
| A1 | 120 mm | Foot width |
| H | 242 mm | Height |
| H1 | 125 mm | Centre height of bearing seat |
| H2 | 45 mm | Foot height |
| J | 350 mm | Distance between attachment bolts |
| L | 410 mm | Length |
| N | 32 mm | Length of attachment bolt hole |
| N1 | 26 mm | Width of attachment bolt hole |
| ba | 52 mm | Distance bearing centre line to shaft end |
|---|---|---|
| bc | 76 mm | Distance bearing centre line to end cover |
| J6 | 378 mm | Distance between dowel pins |
|---|---|---|
| J7 | 44 mm | Axial offset of dowel pins |
| N4 | max.8 mm | Diameter of dowel pins |
| A2L | 200 mm | Width across labyrinth seals |
|---|---|---|
| A2T | 252 mm | Width across taconite seals |
| d2 | 212 mm | Diameter of seal |
Breaking loads, housing
| P55° | 620 kN | Breaking load |
|---|---|---|
| P90° | 370 kN | Breaking load |
| P120° | 280 kN | Breaking load |
| P150° | 250 kN | Breaking load |
| P180° | 310 kN | Breaking load |
| Pa | 110 kN | Breaking load |
Yield point, cap bolts
| Q120° | 620 kN | Load carrying ability of cap bolts |
|---|---|---|
| Q150° | 360 kN | Load carrying ability of cap bolts |
| Q180° | 310 kN | Load carrying ability of cap bolts |
Mass
| Mass housing | 22.5 kg |
Mounting information
| Size of cap bolt | M 20 x 100 | |
| Recommended tightening torque for cap bolts | 200 N·m | |
| Recommended diameter for attachment bolts | G | 24 mm |
| Recommended tightening torque for attachment bolts | 665 N·m | |
| Initial grease fill, 20% | 350 g | |
| Initial grease fill, 40% | 650 g |
