RIS 205
Rubber seating ring for insert bearingRubber seating rings in the RIS 2 series are primarily intended to cushion insert bearings in pressed steel pillow (plummer) block housings. Located between the bearing outer ring and housing bore, they dampen vibration and noise and enable the bearings to be displaced slightly in their housings and to accommodate minor shaft expansion or misalignment.
- Cushion the insert bearing
- Dampen vibrations and noise
- Accommodate slight misalignment
Description
Associated bearing
| Bearing outside diameter | D | 52 mm |
|---|
Dimensions
| B | 15 mm | Inner width rubber seating ring |
|---|---|---|
| C | 20.5 mm | Outer width rubber seating ring |
| d1 | 46.4 mm | Inner diameter rubber seating ring |
| d2 | 51.8 mm | Inner diameter rubber seating ring |
| D1 | 62.3 mm | Outside diameter rubber seating ring |
| r | min. 1 mm | Chamfer radius rubber seating ring |
Mass
| Mass rubber seating ring | 0.03 kg |
